Tweet
Can you guys tell me what the prop nut torque should be on a DF 250. Thanks
-
-
this is not a very technical answer.. but..
I don't have a manual handy.. but can tell you how I do it..
needs to be synched up tight and then backed off to enable you to get the cotter pin through the drive shaft.
Art -
Thanks for the reply.. I found my manual. It says 36-43 Ft Lbs.Comment
-
Don't know numbers off the top but I can tell you on shafts that use a cotter pin the torque is much lower than shafts that use the tabbed washer where you bend a tap over.Comment
Comment