DT140 suzuki water tube removal
My DT140 started overheating and spitting water out through the exhaust vent below the engine cover. The amount of water was proportional to the rpm of the engine. As I tore down the jet foot I found that the impeller looked good, but the rubber gasket that mates to the impeller was burnt and shot. I am assuming the gasket or upper part of the water tube where it mates to the lower unit may be shot also. I removed the bolts holding in the water tube but is does not want to come out. Is there a nut above the tube that locks in the tube or does it just pull out with the bushing 09306-16011and permit me to change the bushing? Maybe I just didn't pull hard enough and the bushing is okay. Afraid to break something. What do I do?
Wayne
|
Linear Mode
