This FIXED it!
You just need to increase the diameter of the analog trim sensor's actuator arm's short stubby axle where the plastic down-trim...
Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
This problem investigation just gets deeper and deeper.
Wish I had checked before I left the shop. The analog gauge's trim settings were...Last edited by Melbjim; 03-26-2023, 11:40 AM.
Leave a comment:
-
Additional Discovery.
I have a PDF copy of the DF200A manual (Suzuki 200 HP) but do not see any reference at all to the procedure for resetting...Last edited by Melbjim; 03-20-2023, 03:33 PM.
Leave a comment:
-
The Up Limit Reset procedure failure is really bizarre since it implies to me a firmware bug that may have long existed and this is actually a double...Last edited by Melbjim; 03-20-2023, 01:49 PM.
Leave a comment:
-
Tried both up/down limit switch reset procedures many times - NO JOY. Bummer. But I did learn something. I may have a upper limit switch signal issue...Last edited by Melbjim; 03-20-2023, 01:30 PM.
Leave a comment:
-
Thanks for the info. I was able to use the hydraulic emergency release screw on the port side of transom mount to get the trim to go all the way down...Last edited by Melbjim; 03-19-2023, 03:15 AM.
Leave a comment:
-
Suzuki 200 HP 2017 Trim down range of motion limited
After trailering bost and putting a short 2x4 board under tilted up engine (to prevent bouncing on rams) I can't get the motor all the way down to neural...
No activity results to display
Show More
Leave a comment: