https://www.suzukioutboardforum.com/...-chiptune-df80
https://www.suzukiout...
Murray
Senior Member
Last Activity: Today, 02:20 PM
Joined: 01-30-2017
Location: Alberta Canada
-
Is the base plate bent or is that an optical illusion? I’m not familiar with the older engines but my base plate is flat. When running...Leave a comment:
-
For every 1000’ (305meters) elevation gain you loss 3% hp.
In your case 1500 meters is approx 15% loss of hp.
15% of 15hp=2.25hp lost...Leave a comment:
-
My apologies you are correct. BOAT= Break Out Another Thousand. Good luck on your search....Leave a comment:
-
S e l f f i x e r d o t c o m (All one word) has a genuine Suzuki service manual 2003-2007 DF 70 for $9 pdf. Well worth the money!...Leave a comment:
-
Sound that something is corroded and has been getting worse over time. The link below might help.
https://www.suzukioutboardforum.com/fo...Leave a comment:
-
Could the Shift Position Sensor/ Neutral Safety Switch maybe causing this issue? On my engine I can’t advance the throttle while in neutral. If...Leave a comment:
-
My 10 amp fuse is inches from the positive terminal on the battery(single engine) so if it’s not at the helm…Leave a comment:
-
Water in the fuel? I always add Seafoam to my tank as a preventative maintenance. If you do add a fuel treatment check the label that’s it’s...Leave a comment:
-
You can have it all. No sense in settling with a fringe. Our cottage(summer home) is in Northern Saskatchewan, was -40C factoring in wind chill today....Leave a comment:
-
LOL, Ice won’t be off the lake till early May. I recently purchased a 12’ aluminum boat so the Suzuki won’t likely see water till June....Leave a comment:
-
Leave a comment:
-
Western Canada...Leave a comment:
-
In Australia we are having the usual heat waves and in the northern half of the country, the storms and accompanying humidity that makes it so sticky....Leave a comment:
-
I would suggest you start your own post. On the page with the yellow stickies at the top right you will find a light blue box “+New Topic”....Leave a comment:
-
Another thought. If your are still stuck after wiggling and jiggling could you drill out the rivets that hold the latch assembly on the cowl? I’m...Leave a comment:
-
My suggestion would be to work the latch while pushing down on the cowl, maybe push the cowl left and right. If you smack it with a hammer chances are...Leave a comment:
No activity results to display
Leave a comment: