Importkillerrr
Member
Last Activity: 09-22-2023, 10:50 PM
Joined: 05-01-2020
Location: NJ
-
Ok... We took the boat out yesterday. That hour and a half drive to the lake sure was an anxious one!! Starting cold (44 degrees yesterday morning) was... -
I didn't get to go to the lake Friday, life got on the way.
I was able to run the engine on muffs in the driveway though. I could NEVER get the...Leave a comment:
-
Also, I had a question.... Back in the day when I was running a performance Bass boat I used low water nose cones and hydraulic jack plates and we all...Leave a comment:
-
Tomorrow my son and I will be going back up to lake hopatcong to try it out. If you listen closely around 7am est you may just hear me yelling
...
Leave a comment:
-
So after looking and looking one place has the water sensors listed as flow while others have it listed as temp. Are they maybe a dual mode sensor, flow...Leave a comment:
-
That would be cool... If I had one
After researching last night it looks like the tach in my boat isn't a Suzuki but I think it's a ranger...Last edited by Importkillerrr; 09-13-2023, 01:59 PM.Leave a comment:
-
Hmmm.....That's not my tach. My tachometer is only a needle gauge, there isn't a check engine light or anything else on it. I've read a few posts on here...Leave a comment:
-
I'll leave the oil system alone as it's functioning as it should. As far as the carb linkage, they are still in sync.
The linkage I adjusted...Leave a comment:
-
Thank you for replying...I truly appreciate the help.
First off..I have removed the new tach that I installed before I took the...Leave a comment:
-
Thank you for the help!!!
Sorry for the confusion... When I say throttle handle I mean the handle on the control box that only increases...Leave a comment:
-
Anybody?!?! I need someone to point me in a direction..., I'm out of ideas!
I'm sorry it's a long post but I've read a lot of posts on this...Leave a comment:
-
DT150 won't go over 2000 rpm's... help please!!
The last time I posted here my lower unit was broke, clutch dog I assume but I never got the bearing carrier out because the previous idiot owner welded...
No activity results to display
Leave a comment: