Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
I have had a Bull Kelp leaf wrap around the lower & cause that same issue.??
-
All my Garmin products have a screen for adjusting voltage reading. Measure at the battwith a Volt meter. my 175 is 14.2 - .6 anything above 1200...
Leave a comment:
-
They were/are famous for water intrusion into the sensor. Tilt is the long ram, trim is the two little rams. Once past the reach of the trim rams its...
Leave a comment:
-
Regular bolt don't have enough seal surface for a drain plug. (Expensive lesson) Alu. oil pan & steel bolt = stripped Alu. pan 99.999% of the time....
Leave a comment:
-
How many hours do you have on it? Tighten the thumb screw & don't worry about it? Call whom ever you purchased it from?
- 1 like
Leave a comment:
-
Measure your transom at the center to bottom of boat, that's the length of engine you should have. If your CAVATATION PLATE is anywhere near the (+/-...Last edited by tsturm; 03-28-2021, 04:37 PM.
Leave a comment:
-
Solas props are no better or worse than any other brand. That's all I have used for the last 20 yrs.
Leave a comment:
-
Get a set of ''easy out'' broken screw extractors or left hand / counter clock wise drill bits. Tap correct size easy out in hole of broken zerk &...
Leave a comment:
-
Don't want to get in a pissing match but if you put grease in it, it comes out of both sides of the tilt lock only. Put grease in the center one on the...
Leave a comment:
-
-
-
A teaspoon or more is a leak, 2-3 drops that come out before the oil while draining is probably condensation, if you live in an area with wild temp/humidity...
Leave a comment:
-
Tilt the motor up, port side about midway on the swivel bracket housing is a zerk (or was)
Might take a while shaking the motor back & forth...
Leave a comment:
No activity results to display
Show More
Leave a comment: