Fuel usage calibration without a C10 gauge

[Dominion OffShore]

Hello,
I have a new DF200 and have it connected to a Raymarine MFD via NMEA 2000 network. I do not have a C10 gauge. I have confirmed that the Raymarine MFD does not have a calibration function. Is there any way to calibrate the data output on the engine side?
Thanks - Brett

[Moonlighter]

No.

When you calibrate, you are actually calibrating an equation that resides in the engine interface cable’s software. The display that is used to do the calibration is simply like a computer keyboard that is accessing the interface software and making some adjustments to the fuel data equation.

So its not the engine itself being calibrated.

The following network displays can do the calibration:

C-10 or Simrad IS35 (same thing)
Suzuki SMIS gauge (same as Lowrance LMF400 or 200)
any Lowrance MFD that can display engine data eg all HDS series, and Elite Ti and Ti2. Elite Chirp cant do it.
any Simrad Display that can display engine data eg all NSS, NSO, GO series models.

You can attach any of these displays to the network temporarily, do the calibration, then remove them. The easiest ones to use for this will be C-10, SMIS or LMF, simply because then dont need to be connected to power to work - they get their operating power via their connection to the network. The others will have to have their power cables connected to 12v as well as being plugged into a network T with a network drop cable. Most Suzuki dealers will have a C-10 or SMIS sitting around their workshop to do initial interface configurations and calibrations.

Ask your local dealer if they will loan one to you, its a quick job half an hour will see it done easily including attaching the display to the network and taking it off again. The callibration process takes only a minute. But, it usually has to be done several times, the system only allows small incremental changes each time. Detailed instructions in the sticky thread on Suzuki networks near the top of this forum, the attached info paper to that thread.

The reason that it has to be one of these is because the Suzuki engine interface is made by Navico, who also make Lowrance and Simrad. Its programmed in their proprietary code so therefore needs a Navico display to talk to it. C10 is really a Simrad IS35 gauge with customised Suzuki features.

[Dominion OffShore]

Thank you!