confused

[boatman170]

Good morning. I have a 99 Suzuki DT 200 that was sending out a code that the book says is the temp cylinder sensor. Replaced the sensor and while engine is running on the flusher I get a single beep . With the engine off I get a single beep then 4 beeps . Engine is pumping water and runs good . Not sure where to go from here ?

[Solarman]

dt200, 99, beeping codes

Do you have a repair manual? Does your monitor light flash at same time, and same signal? If have the manual does it mention audible warnings. If not, then try...
Could try charging the battery, and see if alarm stops, also check battery connections.