I have everything connected on the nmea network. HDS10 recognizes engine. I went through the trim calibration on the screen but it doesn't work. It is on the dashboard but when I trim the gauge doesn't work Its a 2015 and according to your sticky it doesn't have to connected to the trim wires that it is done in the ecu. PLEASE HELP Thanks Bill
PS Maybe I should connect to trim wires under dash.? Right now the plug is used by the Troll Mode Switch, but I can splice
Also it shows trim on the HDS but stays at 100%
PS Maybe I should connect to trim wires under dash.? Right now the plug is used by the Troll Mode Switch, but I can splice
Also it shows trim on the HDS but stays at 100%
Comment