If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
So if anyone have the same SDS system New Bitmap Image.jpg that I have (-up and running?) check what wires go where Next time you happen to have the cover off. I have 5 wires from the engine: 3 that I use (Black-Grey-Orange/yellow) and 2 not in useBlack/Green- Yellow). 4 pin plug from Suzuki SDS : Green-Red-Yellow-Black.
Thanks
My DF115 2007 have /had the big round sds plug with 5 wires in them. When I installed nmea network I replaced that with the square 4 pin. I only needed 3 wires for that to work so I put the 2 extra wires in a second plug 5 wires.jpg as shown in the picture. My network is working 100%. the problem is when I try to connect suzuki diagnose program and that does not work because I put the wires in randomly , (and also there is 5 wires and not 4) SDS plug 4 wires.jpg Does anyone know in what order they go in the connector for it to work with the sds?
Thanks
Leave a comment: